Supermicro AOC-XEH-IN2 Uživatelský manuál stáhnout pdf (Strana 99)

7-1

Chapter 7

1/10-Gb Ethernet Switch Firmware

This chapter is provided to help you quickly get started in using the firmware for your

SBM-GEM-X2C/+ 1/10 Gigabit Ethernet switch module, using the web-based

management GUI tool.

7-1 Overview

The Supermicro switch utility for the 1/10 Gigabit Ethernet switch modules provides a

web-based interface for managing layer2 and layer3 switching at wire speed for

constructing a switched/routed network. This interface provides both a bridging

functionality and advanced features such as link aggregation, Dynamic VLAN/Dynamic

Multicast, IGMP Snooping and Network Access Control. This web-based interface also

comes with several Layer3 features as well (such as wire speed routing, Differentiated

services, multicast routing and so on).

The Supermicro Switch firmware is implemented using open sources from OpenSSL,

OpenSSH and other open source communities and is configured using web browsers

such as Internet Explorer.

The utility starts with a default IP address, which is also the management IP address.

This IP address is essentially provided for remote management of this switch. For

managing the switch through web browsers, type in the default IP address in your

browser’s web address in order to start accessing the switch.

For example, if the management IP address of the switch is 192.168.1.1, the switch can

be accessed through the Web browser by typing http://192.168.1.1 in the address space

of the web browser.

The default management IP address for Supermicro Switch products is

192.168.100.102. This default IP address can be changed in the S

YSTEM SETTINGS page

in the System Management section.

NOTE: The 1/10 Gigabit Ethernet switch module is available in two versions:

• SBM-GEM-X2C which supports 10 or 14 blade enclosure systems

• SBM-GEM-X2C+ which supports twin-blade (20 blade) systems

Except for the the maximum number of blades supported, these two

products are identical. The “SBM-GEM-X2C/+” part number is therefore

used throughout the rest of this manual to refer to features and

operational characteristics of both versions.

NOTE: See the SM-CLI Guide included on your SuperBlade Switch System

CD-ROM for further information on the 1/10 Gigabit Ethernet switch firmware

and its controls using the CLI.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 391 392

Žádné komentáře

Supermicro AOC-XEH-IN2 Uživatelský manuál Strana 99