
7-181
Chapter 7: 1/10-Gb Ethernet Switch Firmware
Candidate RPs
Clicking the CANDIDATE RPS tab brings up the CANDIDATE RP CONFIGURATION page
(Figure 7-161). The parameters for this page are shown in Table 7-130.
CBSR Preference
This parameter indicates the preference value for the local interface as a
candidate bootstrap router.
Row Status This parameter indicates the operational status of the entry.
Figure 7-161. Candidate RP Configuration Page
Table 7-130. Candidate RP Configuration Page Parameters
Parameter Description
Component ID This parameter specifies a number uniquely identifying the component.
Group Address
This parameter represents the multicast group, for which the switch
advertises itself as the candidate RP.
Group Mask
This parameter specifies the subnet mask, which when combined with the
group address gives the group prefix.
RP Address This parameter represents the IP address of the Candidate-RP.
Table 7-129. PIM Interface Configuration Page Parameters (Continued)
Parameter Description
Komentáře k této Příručce