
7-151
Chapter 7: 1/10-Gb Ethernet Switch Firmware
BGP Filter
Clicking the FILTERS tab brings up the BGP FILTER CONFIGURATION page (Figure 7-132),
which is used to set the filters on the routes being learnt. The parameters for this page
are shown in Table 7-106.
Figure 7-132. BGP Filter Configuration Page
Table 7-106. BGP Filter Configuration Page Parameters
Parameter Description
Filter ID This parameter specifies the filter index.
Remote AS
This parameter specifies the remote AS associated with the BGP peer
from which the router is being distributed.
IP Address This parameter specifies the IP address for which the route is being learnt.
IP Address Prefix Length This parameter specifies the prefix length to calculate the Subnet.
Intermediate AS This parameter represents the intermediate AS between the BGP peers.
Direction This parameter indicates the direction of the packet.
Action
With this parameter you can choose either to Allow (not to filter) or Deny
(Filter) for the above configuration set.
Status This parameter specifies the status of the entry.
Komentáře k této Příručce