
7-49
Chapter 7: 1/10-Gb Ethernet Switch Firmware
QOS Policymap Settings
Clicking the POLICYMAP tab brings up the QOS POLICYMAP SETTINGS page (Figure 7-42),
which is used to specify action for a specified classmap. The parameters for this page
are shown in Table 7-31.
Figure 7-42. QOS Policymap Settings Page
Table 7-31. QOS Policymap Settings Page Parameters
Parameter Description
Policy Map ID
This parameter specifies the unique ID for Policymap. The value ranges
between 1 and 65535.
Class Map ID This parameter specifies the CLASS MAP ID to associate with Policymap.
Traffic Rate This parameter specifies the T
RAFFIC RATE of data that has to be applied.
In-Profile Action
This parameter specifies the action to be applied on matched data, and
can be specified as either Policy DSCP or Policy Precedence.
Out-Profile Action
This parameter specifies the action to be applied on out-of-profile data, and
can be specified as either Policy DSCP or Drop.
In-Profile Action Value
The IN-PROFILE ACTION VALUE can be specified from 0 to 7 for DSCP, or
from 0 to 63 for IP Precedence.
Out-Profile Action Value
The O
UT-PROFILE ACTION VALUE can be specified as Drop or from 0 to 63
for DSCP.
Komentáře k této Příručce