
7-179
Chapter 7: 1/10-Gb Ethernet Switch Firmware
Component
Clicking the COMPONENT tab brings up the PIM COMPONENT CONFIGURATION page
(Figure 7-159). The parameters for this page are shown in Table 7-128.
Registration Stop Rate
Limiting Period
This parameter specifies the registration stop rate limiting period in
seconds.
PMBR Status
This parameter allows you to enable or disable the PMBR status in the
switch.
Static RP This parameter allows you to enable or disable the Static RP in the switch.
Figure 7-159. PIM Component Configuration Page
Table 7-128. PIM Component Configuration Page Parameters
Parameter Description
Component ID This parameter specifies a number uniquely identifying the component.
Candidate CRP Hold Time
This parameter specifies the hold time of the component when it is a
candidate RP in the local domain.
Mode
This parameter specifies the mode of the component. It can be Sparse or
Dense.
Table 7-127. PIM Basic Settings Page Parameters (Continued)
Parameter Description
Komentáře k této Příručce