Supermicro AOC-XEH-IN2 Uživatelský manuál Strana 265

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 392
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 264
7-167
Chapter 7: 1/10-Gb Ethernet Switch Firmware
IGMP Snooping Configuration
Clicking the BASIC SETTINGS tab brings up the IGMP SNOOPING CONFIGURATION page
(Figure 7-147), which allows you to configure IGMP snooping parameters. The
parameters for this page are shown in Table 7-118.
Figure 7-147. IGMP Snooping Configuration Page
Table 7-118. IGMP Snooping Configuration Page Parameters
Parameter Description
System Control This parameter Starts or Shutsdown IGS in the switch.
IGMP Snooping Status
This parameter enables or disables IGMP snooping globally in the switch.
To enable IGS, GMRP status must be Disabled.
Operational Status
This parameter enables or disables IGMP snooping operationally in the
switch. To enable IGS, GMRP status must be Disabled.
Proxy Reporting
This parameter indicates whether the proxy reporting in the IGMP
snooping switch is to be enabled or disabled.
Snooping Mode
This parameter specifies the IGMP snooping multicast forwarding mode,
which can be configured using the Destination IP Address or the
Destination MAC Address.
Report Forwarding
This parameter specifies whether the IGMP reports are forwarded on all
ports or only on router ports.
Zobrazit stránku 264
1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 391 392

Komentáře k této Příručce

Žádné komentáře