Supermicro AOC-XEH-IN2 Uživatelský manuál stáhnout pdf (Strana 33)

3-1

Chapter 3

Setup and Installation

This chapter covers the setup and installation of the SuperBladeSuperBlade Ethernet

switch modules.

SuperMicro has two different Gigabit Ethernet switch modules for its SuperBlade

system. The first is the SBM-GEM-001 Gigabit Ethernet switch module with ten external

1-Gbps Ethernet uplinks. The second SBM-GEM-X2C 1/10 Gigabit Ethernet switch

module is a 1-Gbps Ethernet switch with three external 10-Gbps uplink and two external

1-Gbps Ethernet uplink ports. The following pages contain some installation instructions

that are common to both switches.

3-1 Installing/Removing a Switch Module

Follow the procedures below for installing or uninstalling any of the Gigabit Ethernet

switch modules into a SuperBlade system.

Installing a Switch Module

1. Make sure the cover to the module has been installed before proceeding. Follow the

anti-static precautions described in Chapter 2.

2. Remove the dummy cover from the bay you want to place the module in.

3. Place the module's release handle in the open position.

4. Slide the module into the module bay until it stops (see Figure 3-1 and Figure 3-2).

NOTE: The pass-through modules do not require any special setup or

configuration, just installation in their bays.

The SBM-GEM-002 Gigabit pass-through module uses the same single bays as

the Gigabit Ethernet switch modules, while the SBM-XEM-002 10-Gigabit

pass-through module requires a double-wide bay for its installation into the

SuperBlade enclosure. See the SuperBlade User’s Manual for details on

double-wide bay setup.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 391 392

Žádné komentáře

Supermicro AOC-XEH-IN2 Uživatelský manuál Strana 33