
7-149
Chapter 7: 1/10-Gb Ethernet Switch Firmware
Clicking the MULTI-EXIT DISC tab brings up the BGP MED CONFIGURATION page
(Figure 7-130), which allows you to configure the MED value for routes learnt from BGP
peers. The parameters for this page are shown in Table 7-104.
Local Preference
Table 7-104. BGP MED Configuration Page Parameters
Parameter Description
MED ID This parameter specifies the index for this table.
Remote AS
This parameter specifies the AS number from which the route update is
received.
IP Address Prefix
This parameter specifies the IP address prefix for which the update is
received.
IP Address Prefix Length This parameter is used to calculate the subnet.
Intermediate AS This parameter represents the intermediate AS between the BGP peers.
Direction
This parameter can be set for the incoming or the outgoing packets using
In and Out values.
Value
This parameter specifies the MED value to be associated with this path
learnt.
Preference This parameter is used to enable/disable filtering.
Status This parameter indicates the status of the entry.
Figure 7-131. BGP Local Preference Configuration Page
Komentáře k této Příručce