
7-107
Chapter 7: 1/10-Gb Ethernet Switch Firmware
Multicast Filters
Clicking the MULTICAST FILTERS tab brings up the L2 MULTICAST FILTER CONFIGURATION
page (Figure 7-21), which allows you to set the filter configuration to control the
multicast packets that the switch needs to process. The parameters for this page are
shown in Table 7-13.
Allowed Ports
This parameter specifies the list of ports on which the received packet, with
the above set MAC address (if received from the configured port) can be
forwarded.
Status
You can choose to set this configuration to any one of the following types:
• Other – For entries currently in use, but whose conditions remain
different from the following values.
• Permanent – Entries that reside even after the restart of the switch.
• DeleteOnReset – This deletes the entry on restart.
• DeleteOnTimeout – This deletes the entry on expiration of the ageing
timer.
Figure 7-93. L2 Multicast Filter Configuration Page
Table 7-68. L2 Unicast Filter Configuration Page Parameters (Continued)
Parameter Description
Komentáře k této Příručce