Supermicro AOC-XEH-IN2 Uživatelský manuál Strana 167

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 392
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 166
7-69
Chapter 7: 1/10-Gb Ethernet Switch Firmware
Port Control
Clicking the PORT CONTROL tab brings up the PORT CONTROL page (Figure 7-58), which
allows you to configure specific parameters of the port. You can choose between
Auto-negotiation and No-negotiation for a port. If No-negotiation is chosen, then the
speed of the link, FlowControl and duplex modes can be configured. The parameters for
this page are shown in Table 7-41.
Figure 7-58. Port Control Page
Table 7-41. Port Control Page Parameters
Parameter Description
Port This displays the port number.
Mode
This parameter allows you to select either Auto Negotiation or
No-negotiation.
Duplex This parameter allows you to select either Full Duplex or Half Duplex.
Speed
This parameter allows you to select the speed as 10 Mbps, 100 Mbps or
1Gbps.
Flow Control Admin Status
This parmeter allows you to specify the Flow Control Admin Status as
either Disabled, Trasmit Flow Control Enabled, Receive Flow Control
Enabled or both Transmit and Receive Flow Control Enabled.
Flow Control Operation
Status
This parameter displays the status of the flow control.
HOL Block Prevention
This parameter allows you to enable or disable Head of Line block
prevention.
Zobrazit stránku 166
1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 391 392

Komentáře k této Příručce

Žádné komentáře