
Superblade Network Modules User’s Manual
7-168
IGMP Snooping Timer
Clicking the TIMER tab brings up the IGMP SNOOPING TIMER CONFIGURATION page
(Figure 7-148), which configures IGMP snooping timers. The parameters for this page
are shown in Table 7-119.
Retry Count
This parameter specifies the maximum number of group specific queries
sent on a port on the reception of an IGMPv2 leave message.
Query Transmit On TC
This parameter allows you to enable or disable query transmit when
topology changes.
Figure 7-148. IGMP Snooping Timer Configuration Page
Table 7-119. IGMP Snooping Timer Configuration Page Parameters
Parameter Description
Router Port PurgeInterval
(Secs)
This parameter specifies the interval for which the learnt router port will be
purged. The default value is 125-seconds.
Group-Member Port Purge
Interval (Secs)
This parameter specifies the interval after which a port gets deleted, if
IGMP reports are not received on a port. The default value is
260-seconds.
Table 7-118. IGMP Snooping Configuration Page Parameters (Continued)
Parameter Description
Komentáře k této Příručce