
7-183
Chapter 7: 1/10-Gb Ethernet Switch Firmware
Static RP
Clicking the STATIC RP tab brings up the STATIC RP CONFIGURATION page
(Figure 7-163), which configure static PIM RPs (Rendezvous Points). The parameters
for this page are shown in Table 7-132.
Figure 7-163. Static RP Configuration Page
Table 7-132. Static RP Configuration Page Parameters
Parameter Description
Component ID This parameter specifies a number uniquely identifying the component.
Address Type This parameter chooses the IPv4 or IPv6 address type.
Static Group Address
This parameter represents the multicast group, for which the switch
advertises itself as the candidate RP.
Static Group Mask
This parameter specifies the subnet mask, which when combined with the
group address gives the group prefix.
Static RP Address This parameter represents the IP address of the candidate RP.
Komentáře k této Příručce