
7-83
Chapter 7: 1/10-Gb Ethernet Switch Firmware
RSTP Basic Settings
Clicking the BASIC SETTINGS tab brings up the RSTP CONFIGURATION page (Figure 7-72),
which displays the various parameters for RSTP configuration. The parameters for this
page are shown in Table 7-51.
Figure 7-72. RSTP Configuration Page
Table 7-51. RSTP Configuration Page Parameters
Parameter Description
System Control This parameter allows you to start or shutsdown RSTP in the switch.
RSTP Status
This parameter allows you to enable/disable the protocol at a global level
on the switch.
Compatibility
This parameter allows you to choose to run the protocol as an RSTP or
STP compatible version.
Bridge Priority
This parameter specifies the BRIDGE PRIORITY, which can be used to select
the root bridge.
Transmit Hold Count
This parameter specifies the maximum number of packets that can be sent
in a given interval. This is configured to avoid flooding.
Default Path Cost Version
This parameter allows you to configure the path cost either as a 16-bit
value or a 32-bit value. This is provided mainly for backward compatibility
with STAP.
Komentáře k této Příručce