
3-7
Chapter 3: Setup and Installation
Figure 3-6. Gigabit Switch Panel
Address Defaults
The following are the default addresses that are initially set. Afterwards, you can change
these values within the program.
Table 3-1. SBM-GEM-001 Switch Module Address Default Settings
Address Default Setting
Default IP Address 192.168.100.102
Default Gateway Address 192.168.100.1
Default Subnet Mask 255.255.255.0
NOTE: If two switches are installed in a SuperBlade system, you will have to
change the IP address of one from the default so that both switches have
unique addresses.
Komentáře k této Příručce