Supermicro SYS-5013C-MT Datový list stáhnout pdf (Strana 43)

Chapter 5: Advanced Motherboard Setup

5-7

5-6 Installing Memory

1. Memory support

The P4SCT+ supports 4 GB of dual-channel, ECC or non-ECC unbuffered

DDR-400/333/266 SDRAM. You must populate both DIMM0A and DIMM1A

and/or DIMM0B and DIMM1B with the same size and type of memory

modules. This will result in dual channel (two-way interleaved) operation,

which is faster than single channel operation.

2. Installing memory modules

Insert each memory module vertically. Pay attention to the notch along the

bottom of the module to prevent inserting it incorrectly. Gently press down

on the DIMM module until it snaps into place in the slot (see Figure 5-5).

CAUTION! Exercise extreme care when installing or remov-

ing DIMM modules to prevent any possible damage.

Host Clock FSB (MHz)

(MHz)

100 400

133 533

200 800

DRAM Data Shown during

(MT/s) POST

266 DDR266

333 DDR266

400 DDR266

266 DDR266

333 DDR333

400 DDR333

266 DDR266

333 DDR320*

400 DDR400

Memory Speeds

* The BIOS displays DDR320 due to a chipset limitation.

To Install: Insert module vertically and press down until it snaps into place. Pay attention

to the bottom notch.

To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from

the slot.

Figure 5-5. DIMM Installation

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 111 112

Žádné komentáře

Supermicro SYS-5013C-MT Datový list Strana 43