Supermicro SYS-7045A-WTB Datový list stáhnout pdf (Strana 63)

Chapter 6: Advanced Chassis Setup

6-3

6-2 Front Control Panel

The front control panel must be connected to the JF1 connector on the serverboard

to provide you with system status and alarm indications. A ribbon cable has bundled

these wires together to simplify this connection.

Connect the cable from JF1 on the serverboard (making sure the red wire plugs

into pin 1) to the appropriate comnnector on the front control panel PCB (printed

circuit board). Pull all excess cabling over to the control panel side of the chassis.

The LEDs on the control panel inform you of system status - see Figure 6-2 for

details. See Chapter 5 for details on JF1.

Figure 6-2. Front Control Panel LEDs

Power

NIC1

HDD

Overheat/Fan Fail

Indicates power is being supplied to the system.

Indicates network activity on LAN port 1.

Indicates IDE device and hard drive activity. On the

SC743SQ-865, this LED indicates SATA hard drive activ-

ity when ﬂ ashing.

When this LED ﬂ ashes, it indicates a fan failure. When on

continuously it indicates an overheat condition (see Chapter

3 for details).

NIC2

Indicates network activity on LAN port 2

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 143 144

Žádné komentáře

Supermicro SYS-7045A-WTB Datový list Strana 63