Supermicro SYS-5013C-T Datový list stáhnout pdf (Strana 59)

Chapter 6: Advanced Chassis Setup

6-3

6-3 System Fans

Two 10-cm blower fans provide the cooling for the SuperServer 5013C-T/

5013C-i. The chassis includes air seals under the blower fans and at the

chassis cross section, which separates the drive bay area from the moth-

erboard area of the chassis to promote better airflow. It is highly important

that the air seal is properly installed and making a good seal in order for the

cooling air to circulate properly through the chassis.

System Fan Failure

The blower fans run at a full 100% rpm. If a fan fails, you will need to have

it replaced with the same type. Contact your vendor or Supermicro for

information on replacement fans.

cabling out of the airflow path. The LEDs inform you of system status. See

Chapter 3 for details on the LEDs and the control panel buttons. Details on

JF1 can be found in Chapter 5.

6-4 Drive Bay Installation/Removal

Accessing the Drive Bays

Serial ATA Drives: Because of their hotswap capability, you do not need to

access the inside of the chassis or power down the system to install or

replace Serial ATA drives. Proceed to the next step for instructions.

CD-ROM/Floppy Disk Drives: For installing/removing a CD-ROM or floppy disk

drive, you will need to gain access to the inside of the 5013C-T/5013C-i by

removing the top cover of the chassis. Proceed to the "CD-ROM and Floppy

Drive Installation" section later in this chapter for instructions.

Note: Only a "slim" CD-ROM drive will fit into the 5013C-T/5013C-i.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 117 118

Žádné komentáře

Supermicro SYS-5013C-T Datový list Strana 59