Supermicro SuperServer 7048R-C1R4+ Uživatelský manuál stáhnout pdf (Strana 10)

1-2

SUPERSERVER 7048R-C1RT/7048R-C1R User's Manual

1-2 Serverboard Features

The SuperServer 7048R-C1RT4+/7048R-C1R4+ is built around the X10DRC-T4+/

LN4+, a dual processor serverboard based on the Intel C612 chipset. Below are

the main features of the X10DRC-T4+/LN4+. (See Figure 1-1 for a block diagram

of the chipset).

Processors

The X10DRC-T4+/LN4+ supports single or dual Intel® E5-2600 (v3) processors in

Socket R3, LGA 2011 sockets. Please refer to our web site for a complete listing

of supported processors (www.supermicro.com).

Memory

The X10DRC-T4+/LN4+ has 24 DIMM slots that can support up to 1.5 TB of Load

Reduced (LRDIMM) ECC registered memory or up to 768GB of registered (RDIMM)

DDR4-2133/1866/1600 memory. Please refer to Chapter 5 for details on installing

memory.

SAS

An LSI 3108 SAS controller is included on the serverboard to support up to eight

SAS 3.0 ports with RAID 0, 1, 5, 6, 10, 50 and 60.

Note: The SAS drives are hot-swappable units. You must have your RAID set up to

enable the hot-swap capability of the SATA drives. Documentation on RAID setup

guidelines can be found on our web site.

SATA

A SATA controller is integrated into the C612 chipset to provide ten SATA 3.0 ports,

which are RAID 0, 1, 10 and 5 capable.

Note: The SATA drives are hot-swappable units. You must have your RAID set up

to enable the hot-swap capability of the SATA drives. Documentation on RAID setup

guidelines can be found on our web site.

PCI-E Expansion Slots

The X10DRC-T4+/LN4+ has two PCI-E 3.0 x16 slots, three PCI-E 3.0 x8 slots and

one PCI-E 2.0 x4 (in x8) slots. Note that the PCI slots are controlled by the CPUs

so only one slot is available if both CPUs are not installed on the board at the same

time. See Figure 1-1 and the serverboard layout in Chapter 5 for details.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 131 132

Žádné komentáře

Supermicro SuperServer 7048R-C1R4+ Uživatelský manuál Strana 10