Supermicro SYS-8015C-TB Datový list stáhnout pdf (Strana 63)

Chapter 6: Advanced Chassis Setup

6-7

Figure 6-5. Removing a SATA Drive from the Server

SATA Backplane

The SATA drives plug into a backplane that provides power, drive ID and bus termi-

nation. A RAID controller can be used with the backplane to provide data security.

The operating system you use must have RAID support to enable the hot-swap

capability of the drives. The backplane is already preconﬁ gured, so there are no

jumpers or switches present on it.

Installing/removing hot-swap SATA drives

The SATA drive carriers are all easily accessible at the front of the chassis. These

hard drives are hot-pluggable, meaning they can be removed and installed without

powering down the system. To remove a carrier, push the release button located

beside the drive LEDs. Then swing the colored handle fully out and use it to pull

the unit straight out (see Figure 6-5).

Note: Your operating system must have RAID support to enable the hot-plug ca-

pability of the SATA drives.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 117 118

Žádné komentáře

Supermicro SYS-8015C-TB Datový list Strana 63