Supermicro SuperStorage Server 6027R-E1R12T Uživatelský manuál stáhnout pdf (Strana 84)

6-6

SUPERSTORAGESYSTEM 6027R-E1R12L User's Manual

6-6 Drive Bay Installation/Removal

Accessing the Drive Bays

You do not need to access the inside of the chassis or remove power to replace or

swap SATA drives. Proceed to the next step for instructions.

Note: Refer to the following ftp site for setup guidelines: <ftp://ftp.supermicro.com/

driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf> and Supermicro's web site for

additional inmformation < http://www.supermicro.com/support/manuals/>.

Warning! Enterprise level hard disk drives are recommended for use in

Supermicro chassis and servers. For information on recommended HDDs,

visit the Supermicro Web site at http://www.supermicro.com/products/nfo/

ﬁ les/storage/SAS-1-CompList-110909.pdf

SATA Drive Installation

These drives are mounted in carriers to simplify their installation and removal from

the chassis. The carriers also help promote proper airﬂ ow for the drives. For this

reason, even empty carriers without hard drives installed must remain in the chassis.

Removing a Drive Carrier

1. Push the release button located beside the drive's LEDs.

2. Swing the handle fully out and use it to pull the drive carrier straight out (see

Figure 6-5).

Mounting a Drive in a Drive Carrier

1. To add a new SATA drive, install the drive into the carrier with the printed

circuit board side facing down so that the mounting holes align with those in

the carrier.

2. Secure the drive to the carrier with four screws, as shown in Figure 6-5.

Note: Your operating system must have RAID support to enable the hot-plug ca-

pability of the drives.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 127 128

Žádné komentáře

Supermicro SuperStorage Server 6027R-E1R12T Uživatelský manuál Strana 84