Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Uživatelský manuál stáhnout pdf (Strana 32)

100

101

Superblade Network Modules User’s Manual

3-2 Configuring the Switch Module

Figure 3-3. Configuring the Switch Module

A Gigabit Ethernet switch module can be configured using two methods (as shown in

Figure 3-3). You may configure it:

• Through the web-based management utility or IPMI (via the CMM module)

• Directly through a command line (using a telnet interface or a serial console)

The management utility and IPMI access the switch module through the CMM module.

To access it directly, use the command line.

Note that any port may be configured as up (active) or down (inactive). All ports are

active by default.

For more detailed information on configuration of the switches, see either Chapter 6:

"1-Gb Ethernet Switch Firmware" on page 6-1 or Chapter 7: "10-Gb Ethernet Switch

Firmware" on page 7-1.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 333 334

Komentáře k této Příručce

Žádné komentáře

Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Uživatelský manuál Strana 32

Komentáře k této Příručce