Supermicro Superblade SBM-GEM-002 Gigabit Ethernet module Uživatelský manuál Strana 231

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 334
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 230
145
Chapter 7: 10-Gb Ethernet Switch Firmware
Basic Settings
Clicking on the BASIC SETTINGS tab opens to the BGP BASIC SETTINGS page
(Figure 7-113). Table 7-90 lists the parameters found on this page.
Figure 7-113. BGP Basic Settings Page
Table 7-90. BGP Basic Settings
Parameter Description
Status
Specifies the BGP admin status. Using this, the protocol can be Enabled/
Disabled in the switch.
AS Number
Specifies the autonomous system to which the switch is connected.This is
a read-only field.
Synchronization Enables/disables the synchronization between IGP and BGP.
Overlap Router Policy
Represents the policy for handling overlapping routes. When an
overlapping route is received, depending upon the configured policy either
the less-specific routes or most-specific routes or both are installed in the
RIB (Routing Information Base) tree.
Default Local Preference Sets a preference value for the autonomous system path.
Zobrazit stránku 230
1 2 ... 226 227 228 229 230 231 232 233 234 235 236 ... 333 334

Komentáře k této Příručce

Žádné komentáře