Supermicro 2016Ti-HTRF Uživatelský manuál stáhnout pdf (Strana 59)

Chapter 5: Advanced Motherboard Setup

5-25

BMC Enable/Disable

The JPB jumper is used to enable or

disable the onboard Baseboard Man-

agement Controller (BMC) and IPMI.

This jumper is used together with the

IPMI settings in the BIOS. The default

position is enabled. See the table on

the right for jumper settings.

BMC

Jumper Settings

Jumper Setting Deﬁ nition

Pins 1-2 Enabled

Pins 2-3 Disabled

VGA Enable/Disable

Jumper Settings

Both Jumpers Deﬁ nition

Pins 1-2 Enabled (Default)

Pins 2-3 Disabled

VGA Enable

JPG1 allows you to enable or disable

the onboard VGA connector. The

default position is on pins 1 and 2

to enable VGA. See the table on the

right for jumper settings.

Hot Swap Enable/Disable

When two X8SiT-HF motherboards

are installed in a chassis, it is possible

to power down one motherboard for

servicing while the other continues

operating. JPEN1 allows the user to

enable motherboard 'hot-swapping',

which enables this feature. The de-

fault setting is enabled.

Hot Swap

Jumper Settings

Jumper Setting Deﬁ nition

Pins 1-2 Enabled

Pins 2-3 Disabled

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 105 106

Žádné komentáře

Supermicro 2016Ti-HTRF Uživatelský manuál Strana 59