Supermicro AOC-SAT2-MV8 Datový list

Rev. 1.0® SUPERUSER'S GUIDEAOC-SAT2-MV8

AOC-SAT2-MV8 User's Guide103. Installing the SAT2-MV8 Driver3.1 Creating the driver floppy disk:A CDROM that contains the drivers for the Wi

11b. Start the Windows OS. The Windows OS will launch the "Found NewHardware Wizard" and search for the installer driver.c. Insert the drive

AOC-SAT2-MV8 User's Guide123.3 Installing the driver into a new system(*Note: A new system is a system that has no operating systeminstalle

13For the Red Hat Linux Operating Systema. Insert the Linux Driver into your floppy disk drive and press <Enter>. ALinux bootup screen will dis

AOC-SAT2-MV8 User's Guide14For the SuSE Linux Operating System(*Note: The screen shot shown below was taken from a system based onthe SuSE Li

154. Troubleshooting1. Problem: The SAT2-MV8's BIOS does not show up in DOS.Recommended Solutions:• Make sure that the system has enough expansio

AOC-SAT2-MV8 User's Guide163. Problem: I cannot see the hard drives that are connected tothe controller.Recommended Solutions:• Make sure tha

175. Contacting SupermicroHeadquartersAddress: SuperMicro Computer, Inc.980 Rock Ave.San Jose, CA 95131 U.S.A.Tel: +1 (408) 503-8000Fax: +1 (408) 50

AOC-SAT2-MV8 User's Guide186. Product Compliance InformationThe SAT2-MV8 is compliant with the following safety standards/requirements:* USA:

AOC-SAT2-MV8 User's Guide2The information in this User’s Guide has been carefully reviewed and is believed to beaccurate. The vendor assumes

3Table of Contents1. Introduction...41.1. Overview...

AOC-SAT2-MV8 User's Guide41. IntroductionThis manual is written for system integrators, PC technicians andknowledgeable PC users who intend t

5ACT 7ACT 6ACT 5ACT 4ACT 3ACT 2ACT 1ACT0PRE 0PRE 2PRE 3PRE 4PRE 5PRE 1PRE 6PRE7Ext. ACT LEDJS9SATA I2C50CN388SX6081Marvell SATAControllerSAT2-MV8Rev.

AOC-SAT2-MV8 User's Guide6ACT 7ACT 6ACT 5ACT 4ACT 3ACT 2ACT 1ACT0PRE 0PRE 2PRE 3PRE 4PRE 5PRE 1PRE 6PRE7Ext. ACT LEDJS9SATA I2C50CN388SX6081M

71.3 LED Indicators and Pin DefinitionsSATA Presence LEDIndicatorsSerial ATA Presence LED Indica-tors (DS0-DS7) indicate the pres-ence of SATA ports

AOC-SAT2-MV8 User's Guide8RAID SMB (I2 C) ConnectorRAID SMB I2 C Connector (JS10),monitors the status of RAID forSerial ATA ports. See the

92. Safety GuidelinesTo avoid personal injury and property damage, please carefullyfollow all the safety steps listed below when accessing yoursystem